User manual

Operating Procedures 4
N9360A Multi UE Tester W-CDMA User Manual 4-25
Testing Mobile Phone Using Automatic Test
Downlink TX Power
Set the following parameters on the [Configuration: Test
Sequence] screen for downlink output power in Automatic Test:
• BS Level
• Measurement BS Level
• Openloop BS Level
• FreqError BS Level
• BER BS Level
The BS Level setting is applied to signaling steps. In RF Test,
different downlink TX powers are applied depending on
measurement items.
• Open Loop TX Power: Openloop BS Level
• Inner Loop TX Power and Max TX Power: Measurement
BS Level
• Frequency Error: FreqError BS Level
• Sensitivity/BER: BER BS Level
Figure 4-16 shows the condition of downlink TX power in
Automatic Test.