User manual

Operating Procedures 4
N9360A Multi UE Tester W-CDMA User Manual 4-15
2 Press the W-CDMA softkey to select the W-CDMA system.
The [Initial] screen for W-CDMA is displayed after the
Tester completes its initialization and self-test routine.
Figure 4-11 [Initial] Screen
3 Press the Config softkey on the [Initial] screen, and then
press the Tes t Condi tion softkey on the [Configuration]
screen. The [Configuration: Test Condition] screen as
shown in
Figure 4-12.
NOTE
When the AutoBoot function is set to FUNC GSM, FUNC W-CDMA or
FUNC CDMA2000, the Tester automatically selects the GSM, W-CDMA or
cdma2000 system mode if no softkey is pressed within the specified time
(10 to 60 seconds). When the Tester is shipped, the AutoBoot function is
set to
None. Refer to the “AutoBoot" on page 5-10 for details.