User manual

Operating Procedures 4
N9360A Multi UE Tester W-CDMA User Manual 4-9
Selecting Items and Changing Parameters
Depending on the function modes, the Tester has a number of
input fields to be specified or defined to configure a test flow,
test sequence and test condition. The allowable ranges for those
input fields depending on the radio systems are explained in the
following parts of this guide. Summarized information is
described in “Appendix A Input Fields and Allowable Choices
or Ranges" on page A-1.
Selecting an Input Field and Specifying a Value
All input fields to be specified are highlighted and the circular
cursor is shown next to an input field.
To specify a value, select an input field and then specify a value
to the input field by the following procedure:
1 Rotate the CURSOR CONTROL knob clockwise to move
the cursor downward or right, or rotate it
counterclockwise to move it upward or left, and place it
next to the input field you want to change.
2 Press the CURSOR CONTROL knob once. The highlighted
input field changes to normal display and circular cursor
changes to a triangular one.
3 Rotate the CURSOR CONTROL knob clockwise or
counterclockwise to find the values defined for it.
4 Press the CURSOR CONTROL knob to enter the desired
value in the input field. The input field is highlighted
again and the triangular cursor returns to the circular
one.