User manual

4-4 N9360A Multi UE Tester W-CDMA User Manual
4 Operating Procedures
Installing The Test USIM
Insert the TEST Universal Subscriber Identity Module (USIM)
provided by Agilent in the mobile phone before performing any
test. This is because the Tester will not be able to perform
measurements with a USIM provided by the cell phone operator
or other test USIMs.
Connections
Connecting Mobile Phone
Connect the mobile phone to the Tester using any of the
following methods.
Using the Antenna Coupler
Connect the Antenna Coupler (type N9360A-A02) connector to
the RF IN/OUT connector on the front panel of the Tester. Insert
the antenna of the mobile phone into the hole of the Antenna
Coupler as deep as possible.
Using a User-Supplied RF Cable
If you have a cable which connects between the RF port of the
mobile phone and the RF IN/OUT connector of the Tester, use it
instead of the Antenna Coupler.
Using the Shield Case
Connect the ANTENNA COUPLER IN/OUT connector of the
shield case (type N9360A-S01) to the RF IN/OUT connector on
the front panel of the Tester. Place the mobile phone on the
antenna coupler board inside the shield case using the
horizontal and vertical holders.