User manual

Operating Procedures 4
N9360A Multi UE Tester W-CDMA User Manual 4-3
Test Preparat io n
The following procedures are require before proceeding with
any test:
System Requirements
• The following equipment are required to setup the test
system:
• The Agilent N9360A Multi UE Tester.
• An RF cable, RF antenna coupler (type N9360A-A02) or
shield case (part number type N9360A-S01) to connect RF
signals to the mobile phone under test.
• A printer and a printer cable if required.
Figure 4-2 Typi c al Te st S et u p
CAUTION
Make sure that the input signal level does not exceed the maximum
level allowed. Otherwise, Tester failure may occur.