User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-193
† The changing magnification softkey is available. Refer to “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
Gateway Sets the Gateway addresses for gateway setting from 1 to 5. Allowable settings are as follows:
1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168.1.255 are unavailable to setting.)
• The IP address setting supports Class A through Class C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The gateway setting is valid when you set the allowable address, and the Tester and the
Gateway belong to the same network.
• If the Gateway is set to None when booting, the address is displayed as (0.0.0.0), which
means invalid.
• When the Tester and Gateway do not belong to the same network, "Unreachable" is displayed
in the Status field.
• The Gateway setting is effective after the pressing the Apply Address softkey.
CIDR Sets the subnet masks for the destination address in CIDR format from Setting 1 to 5. Allowable
setting values are as follows:
None or 1 to 31
• When the CIDR is set to "None", the "Host/Net" setting is recognized as a host address.
• When the CIDR is set to value other than "None", the "Host/Net" setting is recognized as
network address.
• If the "Gateway" setting is disabled when booting, "None" is displayed in the CIDR field.
• Changes to the mask setting is effective after pressing the Apply Address softkey.
Refer to “Appendix A Input Fields and Allowable Choices or Ranges" on page A-1 for details.
Table 5-53 [Configuration: Network Setting] Screen
Input Field Description