User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-139
† The changing magnification softkey is available. Refer to “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
‡ Refer to “Physical Channel Parameters of Signal Generator" on page D-2 about the
parameters of physical channel for transmitting and receiving in the Signal Generator
mode.
The following are also displayed on the screen field:
• 3GPP-SYS and SIG-PTN
The 3GPP system and the signaling pattern that are
currently set on the Configuration: Test Condition
screen are displayed at the lower-right corner of the
screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the tester is
output to the RF In/Out connector.
Message Field
The following message is displayed in the message field on the
Measurement Result screens:
"Set mobile phone to TX mode and press [Trigger]."
The word surrounded by [ ] in the message field above denotes
softkey.
Averaging Averages respective measurement values of Frequency Error and EVM.
Set the averaging number from 2 to 99 or "Off".
When this function is not required, select "Off".
Table 5-42 [TX Analyzer: Measurement] Results Screen Input Field Descriptions (continued)
Input Field Description