User manual

5-132 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
† The changing magnification softkey is activated. Refer to “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
‡ Refer to “Physical Channel Parameters of Signal Generator" on page D-2 about the
parameters of physical channel for transmitting and receiving in the Signal Generator
mode.
The following are also displayed on the screen field:
• 3GPP-SYS and SIG-PTN
The 3GPP system and the signaling pattern that are
currently set on the Configuration: Test Condition
screen are displayed at the lower-right corner of the
screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the tester is
output to the RF In/Out connector.
Message Field
The following message is displayed in the message field on the
TX Analyzer: Stand-by screen:
"Set mobile phone to TX mode and press [Trigger]."
The word surrounded by [ ] in the above message field denotes
softkey.
Modulation ‡ Sets the modulation mode from the followings:
• IDLE: Outputs CPICH, P-CCPCH, SCH, PICH and S-CCPCH.
• IDLE+DPCH(PN9): Outputs IDLE (without S-CCPCH) Ç RMC 12.2kbps(PN9).
• IDLE+DPCH(PN15): Outputs IDLE (without S-CCPCH) Ç RMC 12.2kbps(PN15).
• IDLE+DPCH(PN9)+OCNS: Outputs IDLE (without S-CCPCH) Ç RMC 12.2kbps(PN9)+OCNS.
• IDLE+DPCH(PN15)+OCNS: Outputs IDLE (without S-CCPCH) Ç RMC 12.2kbps(PN15)+OCNS.
This Modulation setting works with the one on the [Signal Generator] screen. This is set to IDLE
when the [TX Analyzer] screen is displayed while the "Modulation" field on the [Signal
Generator] screen is set to "Off" or Modulation for "HSDPA" is set.
Averaging Averages respective measurement values of Frequency Error and EVM.
Set the averaging number from 2 to 99 or "Off".
When this function is not required, select "Off".
Table 5-41 [TX Analyzer: Stand-by] Screen Input Field
Input Field Description