User manual

5-124 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
† The changing magnification softkey is activated. Refer to “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
Ec/Ior Sets the code power of the DPCH, HS-SCCH, HS-PDSCH by fixed combination.
The available combination is defined by the combination of the FRC Type, Modulation Type, UE
Category.
The HS-PDSCH code power stated above is the total amount of HS-PDSCH code power of each
Channlisation Code.
Refer to Ta ble 5-2 9.
FRC Type Sets the FRC type and each Modulation type that can be set.
Allowable range is as follows:
FRC type: H-set1 to 5, CQI1 to 30.
Modulation Type: QPSK, 16QAM.
QPSK and 16QAM: Varied according to the combination of FRC type and UE Category.
Refer to Ta ble 5-2 9.
Meas. Type † Sets measurement period mode and measurement period number.
Measurement period mode is selected from TTI and CQI.
Allowable range of measurement period number is from 1 to 100000 in 1 step.
• TTI
Measurement period is defined by the TTI period shown by the measurement value.
The parenthesized value is calculated by "measurement period number * 2ms".
• CQI
Measurement period is defined by how long it takes before attaining the CQI reporting value
shown by the measurement period number.
H-ARQ retrans Sets the time of retransmission of H-ARQ.
Select 1 or 4.
UE Category Sets UE Category.
Allowable range is from 1 to 6, 11, and 12.
The setting range of Modulation Type of FRC Type and Ec/Ior are varied by the combination of
FRC Type and UE Category.
Refer to Ta ble 5-2 9.
CPICH RSCP Sets whether or not to display the CPICH RSCP value reported by a mobile phone.
Select "On" or "Off".
• On: Displays the CPICH RSCP value. Activates the
Measurement CPICH RSCP softkey in the Connection status.
• Off: Not display the CPICH RSCP value.
When it is set to "On" in the [Stand-by] status and MS or BS call is started, CPICH RSCP is
reported once and displayed on the screen.
Table 5-36 [Manual Test] Measurement Result Screen Input Field
Input Field Description