User manual

5-88 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
† The changing magnification softkey is activated. Refer to “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
The information from the mobile phone and the tester, as shown
in Table 5-24, is displayed at the lower left corner in the screen
field.
Averaging Averages respective measurement values of Frequency Error and EVM.
Set the averaging number from 2 to 99 or "Off".
When this function is not required, select "Off".
BER Frames † Sets the number of test frames for BER measurement. The allowable range is from 1 to 4100 in 1
step. (1 Frame = 1 TTI)
Also, a bit number according to BER Frames is displayed between parentheses. The bit number
is calculated by an equation "BER Frames multiplied by 244". While BER Frames is entered, The
bit number is displayed in conjunction with the value of BER Frames.
CPICH RSCP Sets whether or not to display the value of CPICH RSCP reported from the mobile phone.
Select "On" or "Off".
• On: Displays CPICH RSCP and also activates the Measurement CPICH RSCP softkey in
connection status.
• Off: Not displays CPICH RSCP.
If this is set to "On" in the Stand-by status, the value of CPICH RSCP is reported from the mobile
phone and displayed on screen after MS or BS Call is started.
Table 5-23 [Manual Test] Measurement Result Screen Input Field
Input Field Description
Table 5-24 [Manual Test] Measurement Result Screen Mobile Phone
Information
Item Information Description
IMSI Displays the International Mobile Subscriber Identity
received from the mobile phone.
IMEI Displays the International Mobile Station Equipment
Identity received from the mobile phone.
Caller ID Displays addresser number sent from the tester at BS Call
execution.
Dialed No. Displays the dialed number received from the mobile phone
at MS call execution.
PRACH Power Displays PRACH Power transmitted from the mobile phone.
CPICH RSCP Displays CPICH received code power reported from the
mobile phone.