User manual

5-78 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
† The changing magnification softkey is available. “Storing Numeric Values" on
page 4-10 and “Changing Magnification Softkey" on page 4-13.
The information from the mobile phone and the tester, as shown
in Table 5-22, is displayed at the lower left corner in the screen
field.
The following are also displayed on the screen field:
• 3GPP-SYS and SIG-PTN
The 3GPP system and the signaling pattern that are
currently set on the Configuration: Test Condition
screen are displayed at the lower-right corner of the
screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the tester is
output to the RF In/Out connector.
Table 5-22 [Manual Test] Connection Screen Mobile Phone Information
Item Information Description
IMSI Displays the International Mobile Subscriber Identity
received from the mobile phone.
IMEI Displays the International Mobile Station Equipment
Identity received from the mobile phone.
Caller ID Displays addresser number sent from the tester at BS Call
execution.
Dialed No. Displays the dialed number received from the mobile
phone at MS call execution.
Keypad information (IA5 characters) of DTMF (Dial Tone
Multi Frequency) is displayed up to 20 digits in the order
of the dialed number sent from the mobile phone.
New numbers are displayed right next to any existing
numbers on the screen. When the number of digits
reaches 20, the digits scroll to left and the oldest digit is
deleted. If the connection is made by an emergency call,
"Emergency Call" display is deleted and number from
which the call was made from the mobile phone is
displayed at the start position of the line.
PRACH Power Displays PRACH Power transmitted from the mobile
phone.
CPICH RSCP Displays CPICH received code power reported from the
mobile phone.