User manual

5-68 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
When the location update is passed, start the test with the
following two method.
• Press the BS Call softkey to start the BS Call.
• Dial and press an Off Hook button on the mobile phone.
When one of above procedures is performed, the screen changes
to a [Measuring] screen, and the test on the mobile phone
starts.
Softkey Field
Softkey Menu
Abort: Aborts location update. This softkey does not appear
when location update is started by the operation of turning the
mobile phone on. After abort of location update, the screen
returns to the Stand-by status.
Screen Field
The input field in the screen field can be changed for a new test.
Refer to Table 5-18, “[Manual Test: Stand-by] Screen Input
Field,” on page 5-63. Also, refer to Table 5-19, “[Manual Test:
Stand-by] Screen Mobile Phone Information,” on page 5-65 for
the information from the mobile phone that is displayed in the
screen field.
Also, the followings are displayed in the screen field.
• 3GPP-SYS and SIG-PTN
The 3GPP system and the signaling pattern that are currently
set on the [Configuration: Test Condition] screen are
displayed at the lower-right corner of the screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the Tester is output
to the RF In/Out connector.