User manual

5-66 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
The followings are also displayed in the screen field.
• 3GPP-SYS and SIG-PTN
The 3GPP system and the signaling pattern that are
currently set on the [Configuration: Test Condition]
screen are displayed at the lower-right corner of the
screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the Tester is
output to the RF In/Out connector.
Message Field
The following message is displayed in the message field on the
Stand-by screen:
"Press [Location Update], [BS Call] or dial and call from the mobile."
The words surrounded by [ ] in the above message field denotes
the softkey.
Explanation
Location Update can be started in the following two ways:
• Turn the mobile phone on and then location update
starts automatically.
• Press the Location Update softkey to execute location
update in order to start a new test.
CPICH RSCP Displays CPICH received code power reported from the
mobile phone.
Table 5-19 [Manual Test: Stand-by] Screen Mobile Phone Information
Item Information Description