User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-53
Measurement Result Screen
When all tests in preset sequences are completed, a
Measurement Result screen is displayed in the Stand-by mode.
During the test, the user can then select the appropriate screen
using the softkeys listed in Table 5-15. The screens shown are
where both Sequence 1 and Sequence 2 are set.
Measurement results are shown as follows:
• "Pass" or measurement value
Shown on blue background when the measurement is
passed.
• "Fail" or measurement value
Shown on red background when the measurement is
failed.
The measurement results are shown in different ways
depending on the display mode.
• On the simplified screen, an enlarged "Pass" is shown in
the middle of the measurement result field when all of
the measurement items are passed. Or, an enlarged "Fail"
is shown in the middle of the measurement result field
when there is even one failed measurement in whole
measurement.
• On the detailed screen, a Pass/Fail is shown at each
item cell in the measurement result field.
• On the value screen, a measurement value is shown at
each item cell in the measurement result field.
When some signaling test items and measurement items are set
to be skipped on the Configuration: Test Sequence screen, each
result of tests and measurements is shown by "-" or "---".
Table 5-15 [Auto Test: Stand-by] Measurement Result Screen Selections
Softkey Screen Displayed See
Simple [Auto Test: Stand-by] Measurement Result
Simple screen
Figure 5-25
Detail [Auto Test: Stand-by] Measurement Result
Detail screen
Figure 5-26
Value [Auto Test: Stand-by] Measurement Result Value
screen
Figure 5-27