User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-51
Sequence 2 Screen
Sequence 2 starts after completion of test in Sequence 1 when
"Radio System 2" is set to "W-CDMA" on the Configuration: Test
Sequence screen. If the "Radio System" is set to "----", Sequence 2
does not run.
When Sequence 2 starts, the Auto Test: Measuring screen shown
in Figure 5-24 is displayed.
The status of sequences is shown at the bottom of the screen.
The type of system in Sequence 2 is now underlined.
The test results of sequences are shown as follows:
• "P": Shown on blue background when the test is passed.
• "F": Shown on red background when the test is failed.
Figure 5-24 [Automatic Test: Measuring] Sequence 2 Simplified Screen