User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-39
Message Field
The following message is displayed in the message field on the
Stand-by screens:
"Press [Start] to begin a test."
The word [Start] in the message field denotes a softkey.
Measuring Screen
When the Start softkey is pressed on the [Auto Test: Stand-by]
screen, the [Auto Test: Measuring] screen is displayed, and a
test starts.
The status of sequences is shown in the upper left corner of the
screen. The sequence under the test execution is underlined.
A signaling step under execution, any step from "Location
Update" to "BS Release", is highlighted. For example, the "Talk"
step is highlighted while the "Talk" step is being executed.
The test results of sequences and signaling steps are shown as
follows:
• "P": Shown on blue background denotes the test passed.
• "F": Shown on red background denotes the test failed.
During the test, the user can then select the appropriate screen
using the softkeys listed in Table 5-8.
Table 5-8 [Auto Test: Measuring] Screen Selections
Softkey Screen Displayed See
Simple [Auto Test: Measuring] Simple screen Figure 5-17
Detail [Auto Test: Measuring] Detail screen Figure 5-18
Value [Auto Test: Measuring] Value screen Figure 5-19