User manual

5-38 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
The followings are also displayed in the screen field:
• 3GPP-SYS and SIG-PTN
"3GPP System" and "Signaling Pattern" currently set on
the Configuration: Test Sequence and Configuration:
Test Condition screens respectively are displayed on the
lower-right corner of the screen.
• RF On indicator
"RF On" indicator at the lower-left corner of the screen is
displayed only when the RF signal from the Tester is
output to the RF In/Out connector.
• Radio system
A Radio System (W-CDMA) for each of the sequence 1
and 2 is shown at the upper left of the screen. The
sequence that is currently displayed is underlined.
• If some measurement items are set to be skipped on the
Configuration: Test Sequence screen, "----" is shown at
those item cells in the measurement result field on the
detailed and the value screen.
Also, if some test items in the signaling step are set to be
skipped on the Configuration: Test Sequence screen, "-"
is shown at the corresponding steps in the test result
field.
The information from the mobile phone and the tester, listed in
Table 5-7, is displayed at the upper right corner in the screen
field.
Table 5-7 [Auto Test: Stand-by] Screen With Mobile Phone Information
Item Information Description
IMSI Displays the default value of International Mobile
Subscriber Identity. The preset value 001010123389980 is
displayed at this state.
IMEI This field remains blank at this state.
Caller ID Displays addresser number sent from the tester at BS Call
execution. The set value is displayed at this state.
Dialed No. This field remains blank at this state.