User manual

5-30 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
Automatic Test
Overview
Feature of Automatic Test
• Pass/Fail test results in the test flow and measurement
items are automatically obtained.
• This function executes RF test switching frequencies on
up to six channels automatically. Combining Sequence 1
and Sequence2 enables measurement on up to 12
channels in one test.
• System handover from Sequence1 to Sequence2 can be
executed when the G00 Option is installed.
Automatic Test Setting in Configuration Mode
• Parameters:
The parameters used in Automatic Test are set in the
Configuration: Test Sequence and the Configuration:
Test Condition screen.
• Loss:
The path loss values for each band can be entered on the
Configuration screen to correct the RF attenuation
between the mobile phone and the Tester. Refer to
“Actual Input/Output Level and Correction" on page 4-19
for correction of input/output signal.
• ATT In/Out:
The path loss values for each RFCH can be set on the
Configuration: Test Sequence screen to correct the RF
test results at each RFCH in a band.
• Sequence:
Up to two test sequences can be set in the Configuration:
Test Sequence screen.
NOTE
Each of W-CDMA and GSM can be set for Sequence 1 and Sequence 2. To
execute system handover from Sequence 1 to Sequence 2, set the
Sequence 1 to W-CDMA and the Sequence 2 to GSM.
This manual explains test items only for W-CDMA. Refer to the N9360A
Multi UE Tester GSM User Manual and the N9360A Multi UE Tester
cdma2000 User Manual for GSM and cdma2000 test items.