User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-23
† For numeric value entry, the changing magnification softkey is available. Refer to
“Storing Numeric Values" on page 4-10 and “Changing Magnification Softkey" on
page 4-13
In addition, this screen displays the following information:
• MAC address
• Status: Shows how each address is configured.
• If any abnormality is detected in the IP Addr/Mask
setting, "Invalid" is displayed.
• If any abnormality is detected in the Default Gateway
setting, "Invalid" is displayed.
• If the Tester and the Default Gateway does not belong to
the same network, "Unreachable" is displayed.
• If any abnormality is detected in the Gateway setting,
"Invalid" is displayed.
• If the Tester and the gateway do not belong to the same
network, "Unreachable" is displayed.
Gateway Sets the Gateway addresses for gateway setting from 1 to 5. Allowable settings are as follows:
1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168.1.255 are unavailable to setting.)
• The IP address setting supports Class A through Class C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The gateway setting is valid when you set the allowable address, and the Tester and the Gateway
belong to the same network.
• If the Gateway is set to None when booting, the address is displayed as (0.0.0.0), which means
invalid.
• When the Tester and Gateway do not belong to the same network, "Unreachable" is displayed in
the Status field.
• The Gateway setting is effective after the pressing the Apply Address softkey.
CIDR Sets the subnet masks for the destination address in CIDR format from Setting 1 to 5. Allowable setting
values are as follows:
• None or 1 to 31
• When the CIDR is set to "None", the "Host/Net" setting is recognized as a host address.
• When the CIDR is set to value other than "None", the "Host/Net" setting is recognized as network
address.
• If the "Gateway" setting is disabled when booting, "None" is displayed in the CIDR field.
• Changes to the mask setting is effective after pressing the Apply Address softkey.
Refer to “Appendix A Input Fields and Allowable Choices or Ranges" on page A-1 for details.
Table 5-2 [Network Setting] Screen Input Field
Input Field Description