User manual

5-22 N9360A Multi UE Tester W-CDMA User Manual
5 Screen Reference
Default Gateway Sets active or inactive of the Default Gateway setting, and sets the Default Gateway address. The
allowable settings are as follows:
• None: Default Gateway setting is inactivated.
• ACT: Default Gateway setting is activated.
When "None" is selected, the address setting field is grayed out and inactivated.
1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168. 1.255 are unavailable to setting.)
• The IP address setting supports Class A through Class C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The Default Gateway setting is valid when you set the allowable Default Gateway address, and the
Tester and the Default Gateway belong to the same network.
• When the Tester and Default Gateway do not belong to the same network, "Unreachable" is
displayed in the Status field because the routing from the Tester cannot be resolved.
• If the Default Gateway is set to "None" when booting, the address is displayed as (0.0.0.0), which
means invalid.
• When the Default Gateway setting fails, "Invalid" is displayed in the Status field.
• The Default Gateway setting is effective after pressing the Apply Address softkey.
Setting
1 to 5
Sets "Act/None" (active/inactive) of gateway settings from 1 to 5. The allowable setting is as follows:
• None: The Gateway setting is inactivated.
• ACT: The Gateway setting is activated.
• The Gateway setting is effective after pressing the Apply Address softkey.
When "None" is selected, the address setting field is grayed out and unavailable.
Host/Net Sets the destination host or network addresses for gateway setting from 1 to 5. Allowable settings are
as follows:
• When Host address is specified (When the CIDR is set to None.):
• 1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168.1.255 are unavailable to setting.)
• When Network address is specified (When the CIDR is not set to None):
• 1.0.0.0 to 223.255.255.255 (From 192.168.1.0 to 192.168.1.255 are unavailable to setting.)
• The IP address setting supports Class A through Class C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• When the Gateway setting fails, "Invalid" is displayed in the Status field.
• The Host/Net setting is effective after pressing the Apply Address softkey.
• If the CIDR is set to "None", the Host/Net setting is recognized as a host address.
• If the CIDR is set to value other than "None", the Host/Net setting is recognized as the network
address. In this case, the address of Host part is set to "0". If it specifies the value other than "0",
"Invalid" is displayed in the Status field.
• The address setting is automatically changed to 1.0.0.1 when the address was set to 1.0.0.0 and the
Host/Net setting is changed from network to host.
Table 5-2 [Network Setting] Screen Input Field
Input Field Description