User manual

Screen Reference 5
N9360A Multi UE Tester W-CDMA User Manual 5-21
Softkey Menu
Print Screen: Prints a hardcopy of the screen or stores the screen
image in a USB memory device, according to the "Printer" field
on the [Configuration] screen.
Apply Address: Applies the changes of "IP Addr", "Mask", "Default
Gateway", "Host/Net", "Gateway" and "CIDR" to the Tester. This
softkey is not activated when the [Network Setting] screen is
displayed and no setting is changed. This softkey is activated
when any input field is changed. After applying the settings,
this softkey is inactivated again.
Cancel: Returns to the [Configuration] screen. Values changed
before pressing the Apply Address softkey are reverted to the
former values.
Screen Field
The following input fields need to be set for a new test according
to the following description of Table 5-2.
Table 5-2 [Network Setting] Screen Input Field
Input Field Description
IP Addr Sets the IP address of the Tester. Allowable setting value is as follows:
1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168.1.255 are unavailable to setting.)
• The IP address setting supports Class A through Class C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The default IP address is "192.168.0.1".
• If the IP address setting fails, "Invalid" is displayed in the Status field.
• Changes to the IP address is effective after pressing the Apply Address softkey.
CIDR (Mask)Sets the subnet mask in CIDR format. Allowable setting value is as follows:
1 to 31
• The default mask value is 24 (255.255.255.0).
• If the mask value setting fails, "Invalid" is displayed in the Status field.
• Changes to the mask setting is effective after pressing the Apply Address softkey.
Refer to “Appendix A Input Fields and Allowable Choices or Ranges" on page A-1 for details.