User manual

4-76 N9360A Multi UE Tester W-CDMA User Manual
4 Operating Procedures
Figure 4-65 [Signal Generator] Screen
7 Set the input fields.
8 Press the RF Output On/Off softkey to change "On/Off" state
from "Off" to "On" for transmitting RF signal to the mobile
phone.
9 Press the RF Output On/Off softkey to change "On/Off" state
from "On" to "Off" for terminating the test by Signal
Generator.
10 The user can save this test procedure in the HDD inside
the Tester or a USB memory device. Refer to
“Saving Test
Setup File" on page 5-171.