User manual

4-66 N9360A Multi UE Tester W-CDMA User Manual
4 Operating Procedures
12 When the trigger mode is Cont, press the Trigger Sing/Cont
softkey to terminate continuous measurement.
Measurement value and Pass/Fail results are shown.
13 Also, CPICH RSCP can be measured at the Connection step.
Press the Measurement CPICH RSCP softkey to make the
mobile phone report the value of CPICH RSCP, and then
the value will be displayed.
14 Finish the call. Press the Release softkey to start BS
Release.
Figure 4-55 [Manual Test: Stand-by] After BS Release Screen (HSDPA)
15 You can save this test procedure in the HDD inside the
Tester or a USB memory device. Refer to
“Saving Test
Setup File" on page 5-171.