Technical data

Command Reference 5
Programmer’s Guide 87
Average Restart
[:SENSe]:AVERage:TRACe[1]|2|3|4:CLEar
Restarts the trace average. This command is only available when
average is on.
Example: :AVERage:TRACe1:CLEar
Key access: Trace > More > Average Restart
Sweep Subsection
Sweep Time
[:SENSe]:SWEep:TIME <time>
[:SENSe]:SWEep:TIME?
Specifies the time in which the instrument sweeps the display. A span
value of 0 Hz causes the analyzer to enter zero span mode. In zero span
the X-axis represents time rather than frequency.
[:SENSe]:SWEep:TIME:AUTO OFF|ON|0|1
[:SENSe]:SWEep:TIME:AUTO?
This command turns on/off auto sweep time state.
Example: :SWEep:TIME 5s
Key access: Shift > Sweep > Sweep Time > Auto Man
Sweep Speed
[:SENSe]:SWEep:SPEed NORMal|FAST
[:SENSe]:SWEep:SPEed?
Toggles the sweep speed between normal and fast.
*RST: Fast
Example: :SWEep:SPEed NORMal
Key access: Shift > Sweep > Sweep Setup > Sweep Speed Accuracy/Speed