Technical data

Command Reference 5
Programmer’s Guide 215
Tracking Generator Amplitude Step
:SOURce:POWer:STEP[:INCRement] <value>
:SOURce:POWer:STEP[:INCRement]?
This command sets the amplitude step size of the tracking generator
output. This command is valid after tracking generator is enabled.
Range: 0 to –10 dBm
Example: :SOURce:POWer:STEP 1 dB
Key access: Meas > Amptd Step
Tracking Generator Storing as Reference
:CALCulate:NTData:STORe
This command stores the current trace to Trace 4 as a reference. This
command is valid after tracking generator is enabled.
Key access: Meas > Normalize >Store Ref
Tracking Generator Normalization State
:CALCulate:NTData[:STATe] OFF|ON|0|1
:CALCulate:NTData[:STATe]?
Use this command to turn on/off tracking generator normalization.
*RST: Off
Example: :CALCulate:NTData 1
Key access: Meas > Normalize > Normalize On/Off
Normalization Reference Level
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRLevel <value>
:DISPlay:WINDow:TRACe:Y[:SCALe]:NRLevel?
Use this command to set the normalization reference level.
*RST: 0 dB
Range: –327.6 to 327.6 dB
Example: :DISPlay:WINDow:TRACe:Y:NRLevel -10 dB
Key access: Meas > Normalize > Norm Ref Lvl