Technical data

Command Reference 5
Programmer’s Guide 211
Set Gate Measurement Type
:CALCulate1:FEED1 PEAK|PTAV|AVER|MIN
:CALCulate1:FEED1?
This command to toggle gate measurement type between Average,
Peak, Peak to Average, and Minimum. It’s only available when the
display mode is set to Meter.
Example: :CALCulate1:FEED1 PEAK
Key access: Meas > Peak Setup > Gate Setup > Meas
Set Trigger Type
:TRIGger1:SOURce:ACQN FREErun|CONTinuous|SINGle
:TRIGger1:SOURce:ACQN?
This command toggles the peak power sensor trigger type between
Continuous Trigger, Single Trigger and Free Run.
Example: :TRIGger1:SOURce:ACQN FREErun
Key access: Meas > Peak Setup > Trig/Acq >Acqn
Set Trigger Source
:TRIGger1:SOURce EXTernal|INTernal
:TRIGger1:SOURce?
Use this command to toggle the trigger source between external and
internal. It’s only available for continuous trigger or single trigger.
Example: :TRIGger1:SOURce EXTernal
Key access: Meas > Peak Setup > Trig/Acq > Source
Power Meter Auto Trigger Level State
:TRIGger[:SEQuence]:LEVel:AUTO OFF|ON|0|1
:TRIGger[:SEQuence]:LEVel:AUTO?
This command turns on/off auto trigger level state of power meter
measurement.
Example: :TRIGger:SEQuence:LEVel:AUTO 1
Key access: Meas > Peak Setup > Trig/Acq > Mode