Technical data

210 Programmer’s Guide
5 Command Reference
Set Limit Lower Value
:CALCulate1:LIMit:LOWer[:DATA] <value>
:CALCulate1:LIMit:LOWer[:DATA]?
This command defines the lower limit value.
Range: –200 to +199.99 dBm
Example: :CALCulate1:LIMit:LOWer:DATA -10
Key access: Shift > Limit > Lower Limit
Set Limit Beep
:DISPlay[:WINDow]:DISPrange:BOTTom <value>
:DISPlay[:WINDow]:DISPrange:BOTTom?
Use this command to turn on/off beep warning for limit.
Example: :CALCulate:LLINe:CONTrol:BEEP ON
Key access: Shift > Limit > Limit Beep
Query Limit Fail Result
:CALCulate:LIMit:FAIL?
Use this command to query the limit result. If get the result 0, it means
power meter test result pass the limit. If get the result 1, it means the
power meter test result fail the limit.
Example: :CALCulate:LIMit:FAIL?
Query Limit Failure Count
:CALCulate:LIMit:FCOunt?
Use this command to query the quantity of limit fail test points.
Example: :CALCulate:LIMit:FCOunt?