Technical data

Command Reference 5
Programmer’s Guide 207
Set Gate Length Time
[:SENSe]:SWEep[1]:TIME <value>
[:SENSe]:SWEep[1]:TIME?
This command defines the gate length time of peak power meter
measurement.
Range: 0 to 1 s
Example: :SENSe:SWEep1:TIME 1
Key access: Meas > Peak Setup > Gate Setup > Length
Set Display Resolution
:DISPlay[:WINDow]:NUMeric:RESolution T1|T2|T3|T4
:DISPlay[:WINDow]:NUMeric:RESolution?
This command toggles the readout display resolution between T1 to T4.
The display resolution T4 can achieve the best resolution.
Example: :DISPlay:WINDow:NUMeric:RESolution T4
Key access: Meas > Meas Disp > Resolution
Set Display Auto Range State
:DISPlay[:WINDow]:DISPrange:AUTO OFF|ON|0|1
:DISPlay[:WINDow]:DISPrange:AUTO?
This command turns on/off the display auto range state.
Example: :DISPlay:WINDow:DISPrange:AUTO 1
Key access: Meas > Meas Disp > Disp Range > Auto Range
Set Top Value of Display Range
:DISPlay[:WINDow]:DISPrange:TOP <value>
:DISPlay[:WINDow]:DISPrange:TOP?
This command specify the top value of display range.
Range: –199.99 to +200 dBm
Example: :DISPlay:WINDow:DISPrange:TOP 10dBm
Key access: Meas > Meas Disp > Disp Range > Top