Technical data

204 Programmer’s Guide
5 Command Reference
Set Power Meter Average Count Number
[:SENSe]:AVERage:COUNt <value>
[:SENSe]:AVERage:COUNt?
This command defines the power meter average count number.
Range: 1 to 1024
Example: :AVERage:COUNt 10
Key access: Meas > General Setup > Average > Average > Avg Count
Set Power Meter Average Count Auto State
[:SENSe]:AVERage:COUNt:AUTO OFF|ON|0|1
[:SENSe]:AVERage:COUNt:AUTO?
This command toggles the power meter average count auto state.
Example: :AVERage:COUNt:AUTO 1
Key access: Meas > General Setup > Average > Average > Avg Count
Power Meter Average Step Detect State
[:SENSe]:AVERage:SDETect OFF|ON|0|1
[:SENSe]:AVERage:SDETect?
Use this command to turn on/off step detect state.
Example: :AVERage:SDETect 0
Key access: Meas > General Setup > Average > Average > Step Detect On/Off
Set Power Meter Measurement Interval Time
[:SENSe]:MEASure:INTerval:TIME <value>
[:SENSe]:MEASure:INTerval:TIME?
This command defines the power meter measurement interval time.
Range: 1 ms to 200 s
Example: :MEASure:INTerval:TIME 1ms
Key access: Meas > General Setup > More 1 of 2 > Meas Interval