Technical data

Command Reference 5
Programmer’s Guide 159
Set Scan Channel For Bottom N Sweep By Signal Standard
:CHSCanner:EDIT:BOTTom:STD <value>
:CHSCanner:EDIT:BOTTom:STD?
Use this command to specify the signal standard for Bottom N sweep
method.
Example: :CHSCanner:EDIT:BOTTom:STD "d:/CDMA-AWS_DL.STD"
Key access: Meas > Range Edit > Edit Method Std > Signal Std.
Set Scan Channel Range For Bottom N Sweep By Signal
Standard
:CHSCanner:EDIT:BOTTom:STD:RANGe <value>,<value>
:CHSCanner:EDIT:BOTTom:STD:RANGe?
This command specify scan channel range number for Bottom N sweep
mode. The signal standard should defined before this operation.
Example: :CHSCanner:EDIT:BOTTom:STD:RANGe 10,100
Key access: Meas > Range Edit > Edit Method Std > Signal Std, then >Begin Chn,
> End Chn
Set Custom Scan Channel For Bottom N Sweep
:CHSCanner:EDIT:BOTTom:CUSTom <start freq>,<freq
step>,<bandwidth>,<ch. number>
:CHSCanner:EDIT:BOTTom:CUSTom?
This command specify the customer scan channels for Bottom N sweep
mode.
Example: :CHSCanner:EDIT:BOTTom:CUSTom
10000000,1000000,10000,100
Key access: Meas > Range Edit > Edit Method Custom