Technical data

Command Reference 5
Programmer’s Guide 153
Bottom Cycle
:CHSCanner:SWEep:BOTTom:CYCLe[:STATe] OFF|ON|0|1
:CHSCanner:SWEep:BOTTom:CYCLe[:STATe]?
Use this command to turn on/off Bottom Cycle state. It’s only available
for Bottom N sweep mode.
:CHSCanner:SWEep:BOTTom:CYCLe:VALue <value>
:CHSCanner:SWEep:BOTTom:CYCLe:VALue?
Use this command to define the Bottom Cycle value. It’s only available
for Bottom N sweep mode.
Range: 1 to 10000
Example: :CHSCanner:SWEep:BOTTom:CYCLe:VALue 10
Key access: Meas > Setup > Bottom Cycle
Scan Start/Stop State Switch
:CHSCanner:SWEep[:STATe] RUN|STOP
:CHSCanner:SWEep[:STATe]?
This command toggles the scan state between start and stop.
Example: :CHSCanner:SWEep RUN
Key access: Meas > Scan Start