Technical data

148 Programmer’s Guide
5 Command Reference
Channel Scanner Option Subsystem
The Channel Scanner Option Subsystem provides you the SCPI
command reference for the channel scanner function. Use the command
:INSTrument SA, and command :INSTrument:MEASure
CHScanner to access this subsystem.
Option SCN is required to enable the channel scanner function.
Channel Scanner SWEep Subsection
Sweep Mode
:CHSCanner:SWEep:MODE LIST|TOP|BOTtom
:CHSCanner:SWEep:MODE?
Toggles the channel scanner sweep mode between List mode, Top N
mode and Bottom N mode.
Range: LIST, TOP, BOTtom
Example: :CHSCanner:SWEep:MODE LIST
Key access: Meas > Channel Scanner > Scan Mode
Top N Nu mb er
:CHSCanner:SWEep:TOP <value>
:CHSCanner:SWEep:TOP?
This command specify the scanning channel number of Top N mode.
Need to switch to Top N sweep mode before using this command.
Range: 1 to 20
Example: :CHSCanner:SWEep:TOP 10
Key access: Meas > Channel Scanner > Scan Mode > Top N