Technical data

144 Programmer’s Guide
5 Command Reference
CAT Query Reference Marker X axis Value
:CALCulate:MARKer[1]|2|3|4|5|6:RX?
This command query current reference marker X axis value.
Example: :CALCulate:MARKer1:RX?
CAT Query Reference Marker Y axis Value
:CALCulate:MARKer[1]|2|3|4|5|6:RY?
This command query current reference marker Y axis value.
Example: :CALCulate:MARKer1:RY?
CAT Marker Peak Search
:CALCulate:MARKer[1]|2|3|4|5|6:PEAK
Use this command to perform marker peak search once.
Example: :CALCulate:MARKer1:PEAK
Key access: Shift > Peak > Peak
CAT Valley Search
:CALCulate:MARKer[1]|2|3|4|5|6:VALLey
Use this command to perform marker valley search once. The maker
valley search can find the point with the lowest value in the current
trace.
Example: :CALCulate:MARKer1:VALL
Key access: Shift > Peak > Valley
CAT Limit Beep State
:CALCulate:MARKer[1]|2|3|4|5|6:CPEak OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4|5|6:CPEak?
This command turns on/off the limit beep warning state in cable and
antenna measurement mode.
Example: :CALCulate:MARKer1:CPEak ON
Key access: Shift > Limit > Beep