User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
4System Setting
36 N9340A User’s Guide
Show System
Displays the following hardware, software and
battery information of your analyzer:
Key Access: [SYS] > {More} > {Show system}
Machine Model Battery Info
MCU Firmware Version Name
DSP Firmware Version Serial NO.
FPGA Firmware Version Capacity
RF Firmware Version Temperature
RF Module S/N Charge Cycles
KeyBoard Module S/N Voltage
This Run Time Current
Temperature Charge Status
Source Voltage Remain Time
Power Source Host ID