User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
6 SCPI Command Reference
128 N9340A User’s Guide
DEMOdulation Subsystem
These sub tree commands are used to control the
demodulation after the measurement has been
loaded by[:SENSe]:FREQuency:SPAN:ZERO
AM Demodulation
:DEMod:AM:STATe OFF|ON|0|1
:DEMod:AM:STATe?
This command toggles the AM demodulation func-
tion between on and off.
FM Demodulation
:DEMod:FM:STATe OFF|ON|0|1
:DEMod:FM:STATe?
This command toggles the FM demodulation func-
tion between on and off.
*RST state: Off
Key access: [Span] > {Demode} > {AM (On)}
*RST state: Off
Key access: [Span] > {Demode} > {FM (On)}