User`s guide

2
Setting Key Beep 32
System Setting 33
General system settings 33
Ext Input 34
File 36
Saving a file 36
Deleting a file 37
Loading a file 37
Show System 38
Show Error 39
Perform a Time Base Calibration 40
Preset 41
Factory Default Settings 42
4Making Measurements
Measuring Multiple Signals 44
Comparing Signals on the Same Screen 44
Figure 2. Delta pair marker with signals on the same screen 45
Figure 3. Setup for obtaining two signals 46
Measuring a Low-Level Signal 49
Reducing Input Attenuation 49
Figure 4. A signal closer to the noise level (Atten:10 dB) 49
Figure 5. A signal closer to the noise level (Atten:20 dB) 50
Figure 6. A signal closer to the noise level (Atten: 0 dB) 50
Figure 7. Decreasing Resolution Bandwidth 51
Figure 8. Using the Average Detector 52
Figure 9. Trace Averaging 53
Improving Frequency Resolution and Accuracy 54
Figure 10. Using Frequency Counter 54
Making Distortion Measurements 55
Identifying Analyzer Generated Distortion 55
Figure 11. Harmonic Distortion 55
Figure 12. Identifying Analyzer Distortion (O dB atten) 57
Figure 13. Identifying Analyzer Distortion (10 dB atten) 57
Third-Order Intermodulation Distortion 58
Measuring Phase Noise 61
Figure 14. Measuring Phase Noise (1) 62