User`s guide

3 System and File
30 N9340B User’s Guide
Show System
Pressing [SYS] > {More} > {Show system} displays the
following hardware, software and battery
information of the analyzer:
Show Error
Pressing [SYS] > {More} > {Show Error} accesses a list
of the 30 most recent error messages. The most
recent error will appear at the bottom of the list. If
the error list is longer than 30 entries, the analyzer
reports an error message [–350, Query
overflow]. When in remote control, and the error
list is greater than 30 entries, the error display is
halted and a message at the bottom of the list
informs the user that error exceed 30.
For more information, refer to “Error Messages" on
page 139.
Perform a Time Base Calibration
The N9340B provides a manual calibration function
to calibrate the time base. The analyzer should
warm up for approximately 30 minutes before
calibration.
Machine Model Battery Info
MCU Firmware Version Name
DSP Firmware Version Serial NO.
FPGA Firmware Version Capacity
RF Firmware Version Temperature
RF Module S/N Charge Cycles
KeyBoard Module S/N Voltage
This Run Time Current
Temperature Charge Status
Source Voltage Remain Time
Power Source Host ID