User`s guide
System and File 3
N9340B User’s Guide 27
• LCD
The analyzer turns off the LCD display after a
user- defined idle time. Press any key to
re- activate the LCD display after the LCD
display power- saving mode has been triggered.
• All - Backlight & LCD
The analyzer turns off the both the LCD display
and the backlight after a user- defined idle time.
Press any key to re- activate the backlight and
LCD display after the backlight and LCD
power- saving mode has been triggered.
Switch Timer
Pressing [SYS] > {Switch Timer} > {Timer} sets the time
switch to power on/off the N9340B in a
user- defined time and date. This switch timer
function requires the power supply connected or
charged battery installed.
Press {Repeat Mode Everyday} to set the N9340B boot
up/off in the pre- saved time everyday. The
pre- saved date is invalid in this mode.
IP configuration
The N9340B supports LAN port connection for
data transfer. Press [SYS] > {Setting} > {IP Admin} >
{IP Address Static} to manually set the IP address,
gateway and subnet mask with the proper LAN
information, or just press [SYS] > {Setting} > {IP
Admin} > {IP Address DCHP} to get the IP address in
LAN dynamically according DCHP.
Press {Apply} to enable all the configurations you
set.
NOTE
Pressing [Preset] for more than 1 second will turn off the LCD
display for power saving. Press any key will turn on the display
immediately.