User`s guide

Instrument Messages 6
N9320A Specturm Analyzer 141
Device-Specific Errors
102 Set 50 MHz signal < 0 dBm, do alignment again
There is too much 50 MHz energy at the RF port for
alignments to run. Reduce input power to less than 0 dBm
and run alignments again.
104 1st LO Unlock
The first LO on has lost phase lock. Report this error to the
nearest Agilent Technologies sales or service office.
105 2nd LO Unlock
The second LO has lost phase lock. Report this error to the
nearest Agilent Technologies sales or service office.
201 Option not installed
The desired operation cannot be performed because a
required option is not installed.
204 TG Frequency Limit
The tracking generator has reached the limit of its allowable
frequency range.
211 RBW limited to 1 kHz when Span > 1 MHz
In spans greater than 1 MHz, narrow (digital) resolution
bandwidths, below 1 kHz, are not available.
213 Span limited to 1 MHz when RBW < 1 kHz
In narrow (digital) resolution bandwidths, below 1 kHz,
spans greater than 1 MHz are not available.
214 TG start freq is less than 9 kHz
Tracking generator uncalibrated below 9 kHz.