Technical data

70 N9320A Programmer’s Guide
5 Command Reference
Marker Read Y Value
:CALCulate:MARKer[n]:Y?
Read the current Y value for the designated marker or delta
on its assigned trace. The value is in the Y- axis units for the
current trace (which is often dBm).
Remarks: This command can be used to read the results of marker
functions such as and noise that are displayed in the marker
value field on the analyzer.
CALCulate:NTData Subsection
Normalize the Trace Data
:CALCulate:NTData[:STATe] OFF|ON|0|1
:CALCulate:NTData[:STATe]?
One sweep of trace data is copied to trace 3, which is used
as the reference trace. Then for all subsequent trace sweeps,
display trace 1 = data collected into trace 1 – data in trace
3.
Key Access:
> Tracking Generator > More > Normalize > Normalize On Off
MODE