Technical data

Command Reference 5
N9320A Programmer’s Guide 135
display of trace data prior to the trigger event. A positive
trigger offset value results in an effective delay in the
display of trace data after the trigger event.
The trigger offset value used when the feature is enable will
depend on the following parameters:
• Normal trigger offset value originally entered
• Specific instrument hardware in use
• Sweep time
Key access: > More > More > Trig Offset On Off
Turn Tri gger O ffset On/ Off
:TRIGger[:SEQuence]:OFFSet:STATe ON|OFF
:TRIGger[:SEQuence]:OFFSet:STATe?
This command turns the trigger offset on/off.
*RST: Off
Key access: > More > More > Trig Offset On Off
Trigg er Sour ce
:TRIGger[:SEQuence]:SOURce IMMedi-
ate|VIDeo|EXTernal
:TRIGger[:SEQuence]:SOURce?
Specifies the source (or type) of triggering used to start a
measurement.
Immediate is free- run triggering
Video triggers on the video signal level
External allows you to connect an external trigger source
*RST: Immediate (free- run triggering)
Remarks: Free- run activates the trigger condition that allows the next
sweep to start as soon as possible after the last sweep.
Key access: > More > Free Run|Video|Line|External Pos Neg
Sweep/
Tri g
Sweep/
Tri g
Sweep/
Tri g