Technical data

Command Reference 5
N9320A Programmer’s Guide 133
TRACe Subsystem
The TRACe subsystem controls access to the internal trace
memory of the analyzer.
Transfer Trace Data
:TRACe[:DATA]? <trace_name>
This command transfers trace data from the controller to the
instrument. <trace_name> is TRACE1|2|3|4.
This command is only available for SCPI programming.
Example: :TRAC:DATA TRACE1
Remarks: Commands :MMEM:STOR:TRAC and :MMEM:LOAD:TRAC are
used to transfer trace data to, or from, the internal drive.
Select Trace Display Mode
:TRACe1|2|3|4:MODE WRITe|MAXHold|MIN-
Hold|VIEW|BLANk
:TRACe1|2|3|4:MODE?
Selects the display mode for the selected trace.
Write puts the trace in the normal mode, updating the data.
Maximum hold displays the highest measured trace value for
all the data that has been measured since the function was
turned on.
Minimum hold displays the lowest measured trace value for
all the data that has been measured since the function was
turned on.
View turns on the trace data so that it can be viewed on the
display.
Blank turns off the trace data so that it is not viewed on the
display.
Key access: > Clear Write|Max Hold|Min Hold|View|Blank
View/
Trac e