Technical data

Command Reference 5
N9320A Programmer’s Guide 127
Set the Source Sweep Power Range
:SOURce:POWer:SPAN <rel_ampl>
:SOURce:POWer:SPAN?
Specifies the range of power levels through which the source
output will sweep.
Use :SOURce:POWer:STARt to set the power level at the
start of the power sweep. This command is equivalent to
:SOURce:POWer:SWEep.
*RST: 0 dB
Range: 0 dB to 20 dB
Default Unit: dB
Set the Source Sweep Power Range
:SOURce:POWer:SWEep <rel_ampl>
:SOURce:POWer:SWEep?
Specifies the range of power levels through which the source
output will sweep.
Use :SOURce:POWer:STARt to set the power level at the
start of the power sweep. See also :SOURce:POWer:SPAN.
*RST: 0 dB
Range: 0 dB to 20 dB
Default Unit: dB
Key Access:
> Tracking Generator > More > Power Sweep On Off
Output Power Tracking
:SOURce:POWer:TRCKing <integer>
:SOURce:POWer:TRCKing?
Adjusts the tracking of the source output with the spectrum
analyzer sweep in the present resolution bandwidth.
*RST: This command is persistent. The term persistent means that
the command retains the setting previously selected, even
through a power cycle.
MODE