Technical data

98 N9320A Programmer’s Guide
5 Command Reference
This command, along with commands
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency] and
[:SENSe]:ACPower:OFFSet:LIST:STATe are used to set
an entire array of values. The Table 1 shows the default
array.
Example: Sending fewer than six parameters to these commands will
leave the values of the unspecified offsets unchanged. If you
don’t send settings for all 6 offsets, it will set all the offsets
that you specified, then it will set any remaining offsets to
the same setting as the last offset that you sent.
ACP:OFFS:LIST:BAND 50,50,50,50,50,50
Key access:
> ACP > Chan Integ BW
Set the Offset Freq
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency]
<freq>,<freq>,<freq>,<freq>,<freq>,<freq>
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency]?
[:SENSe]:ACPower:OFFSet:LIST:STATe
OFF|ON|0|1,OFF|ON|0|1,OFF|ON|0|1,OFF|ON|0|1,OFF|
ON|0|1,OFF|ON|0|1
[:SENSe]:ACPower:OFFSet:LIST:STATe?
Enables you to set the frequency difference from the center
of the main channel to the center of the offset for a
maximum of 6 offsets (labeled A- F). It also allows you to
turn on/off the offsets that you want to measure.
*RST: The default value is defined by the selected Offset label. This
command, along with commands
[:SENSe]:ACPower:OFFSet:LIST[:FREQuency] and
[:SENSe]:ACPower:OFFSet:LIST:STATe are used to set
an entire array of values. Please refer to the Table 1.
Example: ACP:OFFS:LIST 50 Hz,75 Hz,100 Hz,125 Hz,150
Hz,175 Hz
ACP:OFFS:LIST:STAT ON,ON,ON,OFF,OFF,OFF
For example, after the above command is sent, sending the
Meas