Technical data

96 N9320A Programmer’s Guide
5 Command Reference
When set to manual, the last measured value is captured
and held, or may be entered by the user. Relative values are
displayed, referenced to the value measured in the main
channel.
*RST: Auto ON
Example: ACP:CARR:AUTO:OFF
Key access:
> ACP > More > Total Pwr Ref/PSD Ref
Set ACP Reference Manual
[:SENSe]:ACPower:CARRier[:POWer] <ampl>
[:SENSe]:ACPower:CARRier[:POWer]?
Set the adjacent channel reference when Total Pwr Ref/PSD Ref
is set to Manual, the last measured value is captured and
held, or may be entered by the user. Relative values are
displayed, referenced to the value measured in the main
channel.
Example: ACP:CARR:-40
Key access:
> ACP > More > Total Pwr Ref/PSD Ref
Set ACP to Total Pwr Ref
[:SENSe]:ACPower:LIMit[:STATe] OFF|ON|0|1
[:SENSe]:ACPower:LIMit[:STATe]?
Pressing ACP > More > Limit turns the testing of the limit line
on or off. When Limit is set to On, each offset is compared to
its upper and lower offset limit. In those cases where the
power exceeds the limit, the pass/fail indicator area show
“FAIL” in red to indicate a failure; if there are none, it
shows “PASS” in green. Any offsets that are in the off state
are not measured and their results will not be displayed on
screen.
*RST: Off
Example: ACP:LIM 1
Key access:
> ACP > More > Limits
Meas
Meas
Meas