Technical data

94 N9320A Programmer’s Guide
5 Command Reference
SENSe Subsystem
Sets the instrument state parameters so that you can
measure the input signal. SENSe subsystem commands used
for measurements in the MEAS menus. These commands may
be used only to set parameters of a specific measurement
when the measurement is active.
[:SENSe]:ACPower Subsection
Set the ACP Average
[:SENSe]:ACPower:AVERage:COUNt <integer>
[:SENSe]:ACPower:AVERage:COUNt?
[:SENSe]:ACPower:AVERage:[:STATe] OFF|ON|0|1
[:SENSe]:ACPower:AVERage:[:STATe]?
To specify the number of measurement averages used when
calculating the measurement result set Avg Number to ON. The
average will be displayed at the end of each sweep. Setting
Avg Number to OFF disables measurement averaging.
*RST: 10/Off
Range: 1 to 1000
Example: ACP:AVER:COUN 10 sets 10 number ACP average.
Key access:
> ACP > Avg Number On Off
Select the Avg Mode
[:SENSe]:ACPower:AVERage:TCONtrol EXPonen-
tial|REPeat
[:SENSe]:ACPower:AVERage:TCONtrol?
Select the type of termination control used for the averaging
function as either Exp or Repeat. This determines the
averaging action after the specified number of measurements
(average count) is reached.
Meas