User`s guide

4 N9320A Spectrum Analyzer
1Overview
6 Function keys hardkeys that are grouped in the upper right
corner of the front panel. Their functions are defined below:
• Preset/System (Local) hardkey accesses the softkeys to
reset the analyzer to a known state, if the analyzer is in
the remote mode, pressing this key returns the analyzer
to the local mode and enables front- panel control.
• Auto Tune hardkey searches the signal automatically and
locates the signal to the center of the graticule. see “Auto
Tune” on page 75.
• BW/Avg hardkey activates the resolution bandwidth
function and accesses the softkey menus that control the
bandwidth functions and averaging.
• Sweep/Trig hardkey accesses the softkey menus to set the
sweep time, select the sweep and trigger mode.
• View/Trace hardkey accesses the softkeys that allow you
to store and manipulate trace information.
• Det/Display hardkey accesses the softkey menus to
configure detector functions and control the display
settings on the analyzer. These include the display line
value, and limit lines used in testing of trace data against
the entered limit values.
• MODE hardkey to select the measurement mode of the
analyzer.
• Meas hardkey accesses the softkey menu selections for
transmitter power measurements such as adjacent channel
power, occupied bandwidth, and harmonic distortion, etc.
Refer to “One- Button Measurements” on page 121.
• Marker hardkey accesses the marker control keys that
select the type and number of markers and their on and
off control.
• Marker-> hardkey accesses the marker function softkeys
that assist with measurements.
• Peak Search hardkey places a marker on the highest peak.
• File/Print hardkey accesses the softkey menus to
configure the file type, save, and recall, and save location
for the file.