Specifications

Remote Interface Configuration
The Web interface is enabled when shipped. To launch the Web interface:
1. Open the Web browser on your computer.
2. Enter the instrument’s hostname or IP address into the browser’s Address field. The following home page will
appear.
3. Click on the Browser Web Control button in the navigation bar on the left to begin controlling your instrument.
4. For additional help about any of the pages, click on the Help with this Page button.
If desired, you can control access to the Web interface using password protection. As shipped, no password is set. To set
a password, click on the View & Modify Configuration button. Refer to the on-line help for additional information about
setting a password.
Using Telnet
In an MS-DOS Command Prompt box type: telnet hostname 5024 where hostname is the instrument's hostname or
IP address, and 5024 is the instrument’s telnet port.
You should get a Telnet session box with a title indicating that you are connected to the power supply. Type the SCPI
commands at the prompt.
52 Agilent N8900 Series Operating and Service Guide