Specifications

Reset State (*RST)
Reset State (*RST)
The power-on/reset state may differ from that shown below if you have enabled power-on state
recall mode from the States menu (see Instrument State Storage).
The following tables show the reset state. These parameters are reset to the indicated values at power-on or after
*RST.
Reset Settings
SCPI Command *RST Settings
CALibrate:STATe OFF
CURRent 0
CURRent:MODE FIXed
CURRent:PROTection:DELay 50 ms
CURRent:PROTection:STATe OFF
CURRent:TRIGgered 0
DISPlay ON
OUTPut OFF
TRIGger:TRANsient:SOURce BUS
VOLTage 0
VOLTage:MODE FIXed
VOLTage:PROTection 120% of rating
VOLTage:TRIGgered 0
The following table shows the as-shipped settings of the non-volatile parameters. These are not affected by power cyc-
ling or *RST.
Non-Volatile Settings
SCPI as-shipped settings
CALibrate:DATE empty string
CALibrate:PASSword 0
OUTPut:PON:STATe RST
Front Panel as-shipped settings
Firmware update password protected Disabled
Agilent N8900 Series Operating and Service Guide 109