Technical data

596 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz
28 Programming Fundamentals
*ESE default Default is 255 which means that every
error/status bit change that has occurred will
be returned with a *ESR? query. You must set
the value of *ESE to choose only the
bits/status that you want returned.
Default is 0 which means that none of the
error/status bit changes that have occurred
will be returned with a *ESR? query. You must
set the value of *ESE to choose the
bits/status that you want returned.
TRIGger commands For these modes, only one trigger source can
be selected and it will be common across the
modes. Also, only one value can be set for the
trigger delay, level, or polarity.
For these modes, a unique trigger source can
be selected for each mode. Also, each trigger
source can have unique settings for the its
delay, level, and polarity.
Saving and recalling
traces
Traces can only be saved when in the Spectrum Analysis mode (MMEM:STOR:TRAC). This is
because the instrument state must be saved along with the trace data and the state data
varies depending on the number of modes currently available in the instrument.
Command Spectrum Analysis, Phase Noise and Noise
Figure Mode
Basic, cdmaOne, cdma2000, 1xEV-DO,
W-CDMA, GSM, EDGE, NADC, PDC Modes